WELLINGTON 600 BRINELL WEAR PIPE
Wellington’s 600 Brinell Wear Pipe is a tough abrasion resistant product manufactured from a special analysis steel. It is available in nominal pipe sizes from 3” to 40” and up to 50 foot lengths.

Advantages:
A special heat treatment process produces a hardness of 600 BHN on the pipes inner surface for extremely tough wear resistant properties.
Because of the high degree of wear resistance achieved by the I.D. hardness it is possible to use standard wall in applications where double or heavier wall pipe was previously required.
Ease of Installation;
Handles similar to standard steel pipe. Request ends prefitted with weld rings, flanges, or plain ends. Note: Request welding instructions and precautions if you will be welding.
Cutting:
Cutting can be done in two ways:
1) Fixed mount or hand held gasoline powered commercial abrasive disc saw (Done in shop or field).
2) Plasma Arc cutting.
Welding:
Standard Low Hydrogen Method 7018 rod. Note: Request welding instructions and precautions if you will be welding.

Custom Sweeps and Bends are also available

Flanges available on request